Pages

Friday, July 10, 2015

Pull Start E50 Bell

I had a damaged E50 bell, one of the notches got bent. I could either bend it back and use it, or cut it off and not have a starter. Well if you have a pull start e50 you dont need the started plate. . . 
I cut the bell down so its only as deep as it needs to be to make contact with the clutch pads. 






I also ripped out the magnet shield and made slots on a Treats CDI so it weights a little less and is easier to adjust the stator position now. 


And Adam from Tres Rayos hooked up some cylinder spacer sleeve for my Polini rebuild. 


No comments:

Post a Comment